I am not able to loft bend in between sheet metal sketches?
Can any one help me in this, why its not happening ?
I am attaching part file.
Can you upload some screenshots? I'm working on SW 2018. Can't see your sketches because of future version.
Try making a small fillet on sketch2. Then select same sides of sketches...
I used 10 mm since it is my default but I sure you can go smaller if you need too,.
Another screen shot since I'm a screen shot nut.
In my opinion, if you are going to bend this part, you may change your design. See attached.
Retrieving data ...