AnsweredAssumed Answered

Sheet Metal Base Flange - cannot create simplest of edge flanges?

Question asked by Dave Krum on Nov 1, 2019
Latest reply on Nov 1, 2019 by Dave Krum

Like • Show 0 Likes0
Comment • 4

Morning All,

Just wondering if anybody ever saw the attached & below screenshots for sheet metal edge flange creation. I've been using this feature to create them for years w/o issue, now when I try to create even the simplest edge flange off a flat sheet metal base flange, it throws an error. Not sure what has occurred. I've tried closing down SW and restarting numerious times as this always seems to fix most issues. Will try to reboot but did this first thing when I got in. I'm on Windows10 running SW2015. Never saw this error before. Thanks in advance for any suggestions.

Josh Helman Nov 1, 2019 9:23 AM

Correct Answer

Could you upload the sheet metal file or send a zoomed out picture so we understand more of where you are placing this?

See the reply in context

Attachments

Untitled.png492.4 KB

No one else had this question

Outcomes

Josh Helman Nov 1, 2019 9:23 AM

Could you upload the sheet metal file or send a zoomed out picture so we understand more of where you are placing this?

Actions

Dave Krum @ Josh Helman on Nov 1, 2019 9:38 AM

Thanks for the response Josh. After rebooting, all is well. I would have tried this first but after a complete shutdown and restart, the problem is gone. Weird. Normally a restart of SW and/or operating system, the issue is fixed but not in this case. I needed a cold boot. Strange. Thanks anyways.

Actions

Steven Calvert Nov 1, 2019 9:52 AM

Looks to me that you have your radius set at 8.75 in soyour flange length may be too short

Steve C

Actions

Dave Krum @ Steven Calvert on Nov 1, 2019 9:56 AM

I see that now. Hmm, good point but I did try another test w/ default unchecked and overrode this value to .01 for knife die on 10 ga. plate and got same error so I don't know. Thanks for response.

Actions

4 Replies

Josh Helman Nov 1, 2019 9:23 AM
Unmark Correct
Correct Answer
Could you upload the sheet metal file or send a zoomed out picture so we understand more of where you are placing this?
Like • Show 1 Like1
Actions
- Dave Krum @ Josh Helman on Nov 1, 2019 9:38 AM
  Mark Correct
  Correct Answer
  Thanks for the response Josh. After rebooting, all is well. I would have tried this first but after a complete shutdown and restart, the problem is gone. Weird. Normally a restart of SW and/or operating system, the issue is fixed but not in this case. I needed a cold boot. Strange. Thanks anyways.
  Like • Show 0 Likes0
  Actions
Steven Calvert Nov 1, 2019 9:52 AM
Mark Correct
Correct Answer
Looks to me that you have your radius set at 8.75 in soyour flange length may be too short

Steve C
Like • Show 2 Likes2
Actions
- Dave Krum @ Steven Calvert on Nov 1, 2019 9:56 AM
  Mark Correct
  Correct Answer
  I see that now. Hmm, good point but I did try another test w/ default unchecked and overrode this value to .01 for knife die on 10 ga. plate and got same error so I don't know. Thanks for response.
  Like • Show 0 Likes0
  Actions

Sheet Metal Base Flange - cannot create simplest of edge flanges?

Attachments

Outcomes

Related Content

Recommended Content