I have been away from Solidworks for a few months and I think I am getting rusty and wondered if someone would be kind enough to point me in the right direction please.
In the attached model I have a flue that is projecting vertically into the ceiling, and I want to make a architrave that attaches to the ceiling plasterboard around the flue. The architrave will be dissected into two halves and then glued around the flue for the final installation.
The problem I am having is how to draw the sketch on the architrave on the lower plane so that I can create a swept cut in order to create a bit of detail for the part.
Many thanks
Alex
Do you mean something like this?