Jacky Hao

reget into the sketch

Discussion created by Jacky Hao on Oct 22, 2019

when i finish a sketch,i suddenly find there is a error in it, so i have to edit the sketch, but i have entered into the (extruded base)feature editing enviroment.if the error in the sketch is that the entity is not close,like i posted in the attach.i have to delete the feature(extruded base),and then edit the sketch,and then extruded base the sketch again.so troublesome,is there a better way?   i use sw 2015. and  could not  deselect the thin feature.

Outcomes