Andres Felipe Lara Guerra

Problem with iteration time

Discussion created by Andres Felipe Lara Guerra on Oct 23, 2019
Latest reply on Oct 23, 2019 by Andres Felipe Lara Guerra

This is a model of the internal chamber of a oven, the reason of the simulation is to show when the chamber got a temperature by 573 K, on this case y have a internal fan ( figure like a wheel), a inlet flow volumen that hava Temperature of 900 K, also I have a heat source with the same temperature of  900K, I put a radiactive surface and decide to use the half part of the oven as the computanional domain in order to have less iteration time

Thoose are my mesh settings and a level 1 and my calculation settings 


The iteration time have the order of 39900 minutes, i´m looking for a way to mesh in order to have less iteration time