AnsweredAssumed Answered

Adding Slope to Pipe routing AFTER the pipe route is done!

Question asked by Khoi Le on Oct 21, 2019
Latest reply on Oct 22, 2019 by Jacky Hao

Hi all, i would like to ask how can we add a slope to a pipe segment after i finish that pipe route. 

 

To be more specific, i finish a pipe route a few months ago, without any slope. My client just contacted me a few days ago, stating that they want to add a slope to a pipe segment somewhere in the pipe route.

 

So this is what i have done: I went into the edit mode, delete the constrains that make that pipe segment fully defined. However, there's an error keep popping up: "slope cannot be created, adjust the slope angle, section length or weld gap and try again". How can we resolved this?

 

I want to add slope to the pipe segment in between the 2 45 bend as shown in the image below.

 

Thank you!

Outcomes