is there a way to open a model that was created in solidworks in solid edge?
You would have better luck getting answer to your question in a solid edge forum.
If I were you I will make SWX file as a parasolid/step file and try to open it in solid edge. I do not know whether it will work.
..I'm pretty sure you can directly open a sldprt and sldasm into SE... otherwise, parasolid.
I use both and go both ways.
This will depend on specific versions. If the destination is 1 year newer than the source, should be able to open it directly.
I have had the best luck using para solid Translation. The most information is translated and feature recognition works well.
S. Leacox wrote: I use both and go both ways.
S. Leacox wrote:
Retrieving data ...