Why does it not work, when I put 2 lines middle on middle and make them kollinear (in 3D-Sketch)?
...my SW is the 2017-edition SP5 without PDM (is installed, but here I do not work with)...
I presume you are talking about a sketch. It is difficult to understand your problem without more information.
Is this what you want?
I made two lines colinear
Then selected the midpoint of one of the lines and gave it a midpoint relation to the other
Exact that is it I want do do; but when I do the same steps like you I get this:
I'm not sure what's going on..
here's a gif of what I did
Thanks so far.
I do the same and it does not work...
I go to check other things like Build and servicepack, or complete other Settings...
What version are you on?
I attach a 2018 file so you can see if it works.
I've got SW2017 SP5
...I can't work with your file :-(
Can you save it as a part and attach it here please
Falk Weigand wrote: Exact that is it I want do do; but when I do the same steps like you I get this:
Falk Weigand wrote:
It looks as if you are picking the midpoint of one line but the actual line on the other where you should be picking the midpoint of both lines in the 3D sketch ...
My best guess is that it isn't working because it's a 3d sketch. If you still need to do this, add a construction line with one end coincident with the midpoint of one of the lines, then you can add the relation between this end point and the midpoint of the other line.
The way I try to solve the Problem is that way:
take the two Middlepoints by clicking (not the Funktion) and make them equal.
and last but not least make them colinear...
...but I still dont understand, why it doesent work the other way :-(
Retrieving data ...