AnsweredAssumed Answered

Question: Closure of a procedure?

Question asked by Patrik Nilsson on Sep 29, 2019
Latest reply on Oct 8, 2019 by Frank Ruepp

I have done many different procedures but a few of them have a minus next to the sketch. There is something that generated this minus but I can not tell what since same type of procedures are closed normally. Is there a way to find out if you left out something the software requires or do you just force the sketch closed? How do an user force a removal of a "minus" next to a sketch in an orderly fashion? Do you have any advice as a specialist, what do you do in this situation?

 

open sketch

Outcomes