Hi i'm trying to build a part of a gaming headset as part of my project and i'm trying to knit all my surfaces together but i keep getting rebuild errors, can anyone take a look. I've attached 2 files, one is made by using only surafces and one is made by surfaces and features like extrude and stuff.
Thanks
thanks for the help and also if I just trim away the places you marked in Xs would I be able to knit everything together. Also is that solid part done only using a revolve?
Sanjutharun,
Yes, you can make this surface a solid just by trimming the extra faces. Feel free to review the features of the attached model. More work than a revolve, but it can be done!
~Ben
I’ve looked at what you’ve done with the part and thanks soo much for the help it really helped me understand how you trimmed and knitted the surfaces together. Is it possible for me to get help from you in the near future as i’m trying to make a gaming headset as part of my project if so it will be greatly appreciated.
Thanks
Sanju
I'm not sure what the end result geometry is you are looking for but from what I can see it looks like you could to most of this with a couple of revolves. However, if you are going to continue to use surfaces remember to trim away the bits you don't need, especially if they end up inside what will be the solid body.
thanks ill give it a try and see if it works
I think it is easy to make everything in solid then proceed. Because if surfaces come in between it will give trouble when you try to kit.