AnsweredAssumed Answered

Flat Pattern is wrong

Question asked by Karine Vallerand on Sep 18, 2019
Latest reply on Sep 18, 2019 by Karine Vallerand

Hi everyone,


I have a problem with a the flat pattern of my part. The flat pattern is simply... Wrong.


Part is a simple piece with 3 bents on 3 adjacent sides, all in the same direction. When I use the unfold function, I get the right pattern, the one with trimmed corners (shown in green). However, when I use the flat pattern as usual in drawings, I get regular 90º corners. There is no way it can be bent properly. 


I usually don't have any issues, so I don't understand why this one is wrong.