AnsweredAssumed Answered

Making the flanges same heigth

Question asked by Matt Juric on Sep 16, 2019
Latest reply on Sep 17, 2019 by John Stoltzfus

This is one of those "Seems like this should be easy" and or "I should know how to do this", questions.

 

I've run into this many times and always just calculated the extension distance but was wondering if there was an easier way. 

 

I have a sheet metal part with flanges at a corner. On flange is at 90 degrees the other is at 60 degree. If these two flanges have the same bend information on is higher than the other. I can add an offset, change the radius etc to get them even. I was however wondering if there was some magical button or approach where I could just say "Make this one even with that one" 

 

 

Thanks

Outcomes