I need to replicate this type of corner relief and I'm having a hard time accomplishing it. I've tried using the Corner Relief function with no success. We're using Solidworks 2018
How can I attach a file to a forum post?
What I often do in a case like this is to pull the flange edges back to there you want the relief to start and then create a tab on the flange to finish it off to the edge. To pull the edge back while creating the flange you select the sketch in the box to the upper right on the dashboard and edit sketch. You can then just grab an end of the flange and pull it back to where you want it. Then add the dimension and you are good to go. I would show pictures but my machine is busy running a simulation.
Thanks for the help. I think I managed to get it to work. You see, we're trying to replicate a fold that was done by our customer who happens to have a very fancy laser cutter and cnc brake. I believe that they did exactly what you had outlined. But then added a 1/32" corner relief and extended each corner to meet closer (probably so they could run a weld bead in there at the time of assembly). I'd like to know HOW they did this. Not that I want to replicate it exactly. Just so that I can say we know how to do it.
Here's a close up shot.
Pull the flange end in as stated previously and add a tab with its own relief notch.
Retrieving data ...