AnsweredAssumed Answered

Inward Rounding Issue

Question asked by Patrick Dunleavy on Sep 11, 2019
Latest reply on Sep 11, 2019 by Matthew Lorono

I have a drawing with millimeters for primary units and inches for secondary units. I have rounding set to "Round half away from zero". I have one dimension that has a tolerance of ±0.15mm, which is equal to ~0.0059in. With the secondary tolerance set to three decimal places, this rounds to 0.006in as expected. When I select "Inward rounding" for this dimension, the secondary tolerance rounds to zero (regardless of number of decimal places displayed).


With three decimal places displayed, shouldn't it round to 0.005in? Am I just not understanding how the inward rounding function works?


Any advice or information is appreciated


Edit: I'm using SW 2016 SP 4.0