I want to add a figure as a block to forming tools and want to scale automaticly when i change the dimensions of model which shown below. how can i done this.
thanks for reading.
The "Only Way I Know" - would be to add your part that you show to an assembly file and then add your forming tool in context within the assembly, then for a different size you would need to Pack & Go and change the part numbers etc..
Considering forming tools must be made (and some are special order), I will suggest creating configurations and suppressing a given tool for another given tool at the new part size.
This way you can control the number of tools and have these at known (and common nominal) sizes and not end up with a pile of tools with some a little bit bigger here and others a little bit smaller there.
"Scaling", even if possible, may randomize the number and sizes of the forming tools.
Figure out your min and max part sizes and the most likely in between proportions and from this, decide on the number and sizes of the forming tools you'll need for these situations.
See how much each tool will cost, sum up your tool tally and see if the tool budget does or doesn't adversely affect part pricing.
If so, decide on fewer part variations or fewer tools shared across more part sizes.
Retrieving data ...