AnsweredAssumed Answered

Moving the part that is created defined and saved in the assembly.

Question asked by Igor Moskalenko on Sep 11, 2019
Latest reply on Sep 11, 2019 by Igor Moskalenko

Moving the part that is created defined and saved in the assembly. How to do?
There is a control sketch in the assembly. Then two parts are inserted into the assembly, and these parts are stored inside the assembly. The geometry of the sketches of these parts is “coradial” and “collinear” with a control sketch.
So everything is all right. The control sketch fully defines the assembly and parts.
But is it possible to move one of these parts?
----------
End aim of that all is to create a flexible “spherical plain bearing” assembly without of saving parts outside assemly..

Outcomes