AnsweredAssumed Answered

Joining by Filleting two CW/CCW Helix

Question asked by Ali Bayati on Sep 6, 2019
Latest reply on Jan 6, 2020 by Justin Hanson

Hi everyone,

I just wanted to create a "Diamond thread" on a shaft (as self reversing screw). I created two helix (CW & CCW) from the same point on a shaft and created two sets of threads using two separated "swept cut" command.

Is there any method to fillet the start and end point of these two helix to make these two vertices round, in order to perform one single "swept cut" command?

 

Self Reversing Screw, Diamond Thread, Levelwinder

Outcomes