AnsweredAssumed Answered

Boundary Conditions Help

Question asked by Zac Wyp on Aug 29, 2019

Hi Everyone,

 

I am trying to run a simulation on the model seen below in which a load is applied to the top of the light grey surface.

                              

I would like to use boundary conditions on each of the sides so that the rods leaving on the left-hand side act as if they were supported by the rods on the right-hand side at the same location.  Theoretically connecting each of the points seen below so that the top layer is completely supported across its full length. 

 

 

Is this possible? If so, how would I go about doing so?

 

Thank you for your help in advance.  

Outcomes