Ben Blick

How to turn off the "snap to grid" feature when using grids.

Discussion created by Ben Blick on Aug 27, 2019
Latest reply on Aug 28, 2019 by Ben Blick

So i have been trying to make a couple polylines along a plane, as this is the only way i have found to draw exploded lines with polylines and not using paths. I am using the grid command to accomplish this.

 

So it work out pretty well, but the "snap to grid" feature ( for a lack of a better term) is enabled and i can't figure out how to turn it off.

 

also if there is any info on the grid feature i would love to see it as i kinda just found it out by clicking on stuff and i have searched a while to find anything on it.

Outcomes