AnsweredAssumed Answered

!@#$%^&* Pack and Go!!!!

Question asked by Kevin Andrews on Aug 21, 2019
Latest reply on Aug 21, 2019 by Glenn Schroeder

OK, I searched through as many headings as I could and did not find any RECENT information pertaining to this problem. The most recent was 2014, from memory.

 

I have an assembly that consists of 7 sub-assemblies. Each sub-assembly has a minimum of 8 components in it. Some have over 40.

 

When I perform a pack and go, it repeatedly leaves out one assembly (the same one and the fixed one at that). No matter what I do, I can not get it to include that assembly nor any of the associated files to that assembly (drawings for example).

I can go in and dissolve the sub-assembly and everything shows up (minus the assembly and drawing for the assembly) but it throws off the overall drawing for the main assembly.

 

I have seen that this is a recurring problem as far back as 2008. Has anyone found a fix for this or know a way around it so that it includes the missing assemblies in the main Pack and Go?

Outcomes