I'm looking to edit this linear pattern, but it doesn't give me the option when I right click. Does this happen when you try to pattern splines?
probably not only me, but lots of people here on forum as well would advice you not to use pattern in sketch....Make your desired shape and extrude it or whatever....and than pattern this feature....
I guess you are looking for this??
Ok understood, thanks for the advice!
I'll add my vote to not using sketch patterns at all. Create a single instance of the feature instead and then pattern it.
Me too, feature pattern are faster and configurable !
Jerome De San Nicolás wrote: Me too, feature pattern are faster and configurable !
Jerome De San Nicolás wrote:
..and much easier to edit.
Sketch patterns are awful when using equation-driven curves (notably in gear teeth). I usually make an extrude surface and pattern that.
Retrieving data ...