Petruvsky Ponolovsky

Need advice modeling a keyboard keycap.

Discussion created by Petruvsky Ponolovsky on Aug 18, 2019
Latest reply on Aug 19, 2019 by Petruvsky Ponolovsky

Hello friends. I'm an amateur who likes to design his own hardware. Everything was going well until I ran into a problem. What I'm doing is this kind of pieces:

Upper row keycap
Normally I would just shave a cube until I get the shape I want for it, but with angled keycaps this method will not work. What I want to do is make a sort of draft to perform this (figure 1) into this (figure 2):
Keycap 12mm upper part "drafted" to 18mm basis.

Unfortunately, I couldn't get the draft tool itself to make what I want. Thank you, I'm waiting for an answer.

Outcomes