AnsweredAssumed Answered

Parts saved internal to assembly file.

Question asked by Tim Cochrane on Apr 15, 2009
Latest reply on May 13, 2009 by Tim Cochrane
I am a bit frustrated with this feature.

In the past I would always save my new parts to a different file and it worked fine.

Yesterday I created an assembly with a single defined part, and 6 other parts referenced to it.

Today when I was finishing up the design I saved all of those parts into different files and saved them where the original part and assembly are located. As soon as I did this all of my references disapeared and the dreaded negative signs were everywhere.

Is there something I am doing wrong or are others having the same problem?

Thanks

Tim

Outcomes