AnsweredAssumed Answered

How to make sub-assembly solve as "flexible" on default?

Question asked by Aaron Zheng on Aug 3, 2019
Latest reply on Aug 6, 2019 by Aaron Zheng

Hi, Solidworks community,


I am designing a humanoid robot for school, and I have quite a large assembly. Many individual components make up this assembly, such as many motor assemblies, part assemblies etcetera. For my purposes, I would like my individual parts in each assembly to move and rotate based on its constraints, rather than the entire assembly acting like a rigid, unmovable body.


However, I feel it is slightly repetitive to consistently go to "Component Properties" and then check "Flexible" instead of rigid. Is there a shortcut to this?


Thank you so much,