AnsweredAssumed Answered

How to run simulation with pressure but no fixtures?

Question asked by Ryan Samuels on Aug 2, 2019
Latest reply on Aug 5, 2019 by Jay Seaglar

I'm currently trying to simulate a vacuum environment on a 3" x 7" panel with a lattice structure inside and am running into some confusion. I don't necessarily need a fixture because there's an equal 14.7 psi force on each side of the rectangular panel, but I don't think SOLIDWORKS is allowing me to proceed without a fixture. How can I proceed to test this panel? The red is the pressure and the green was a displacement fixture on the face (which I think is wrong).

 

Thanks!!

Attachments

Outcomes