I want to create lofted bend which passes through 3 sketches, Which I can Make flatten in sheet metal and roll it.
Or any other technique to create this loft from 3 sketches and convert in sheet metal and make it flatten will also fine for me.
Please give me some ideas so that I can learn and improve my knowledge.
Any idea would be appreciated.
Thank you.
You have to Convert in Zip File and then Attached Zip file. You cant upload Solidworks file directly.
I am glad because fact is conveyed.
You need to make it in 2 loft.
Can't flatten with only one.
Roll the ring and loft the cone.
I need to make it in one cone that's the requirement. Any idea? by doing other way and later convert it in sheet metal.
You can't roll it or bend it as one.
You can't roll the offset cone. It can be "bumped".
Unless I totally misunderstand your sketch.
It always a good idea to extrude the final shape. So you can see what it looks like and decide how to split the flat.
I want to create lofted bend which passes through 3 sketches, Which I can Make flatten in sheet metal and roll it.
Or any other technique to create this loft from 3 sketches and convert in sheet metal and make it flatten will also fine for me.
Please give me some ideas so that I can learn and improve my knowledge.
Any idea would be appreciated.
Thank you.
Not sure why you need 3 sketches to create your part\
From your image, it'd be simply creating 2 sketches and use loft bend to create the part
Sheet Metal loft is between 2 sketches only, if there are 3 sketches you have to make 2 lofts and combine it, but there is no guarantee that final part can be flatten.
How can I attach a file to a forum post?