I have a new one, at least to me.  I have sketches that drive a lofted cut that consist solely of a sketch block attached (Coincident Relation) to an separate 3D sketch.  In some configurations the relation is there and in others it is not.  I go into the one where it is there and look in the Relation Manager and it is unsuppressed in all configurations.  The 3D sketch is likewise unsuppressed in all configurations, as are the Sketch Planes.  Has anyone else seen this?  Perhaps it's a trick you do on purpose?

I'll attach the file if anyone wants to poke around and see if they can figure it out.

Lofted Cuts - DT STEM 1 & DT STEM 2

3D sketch - POCKET LAYOUT SKETCH

Relation is present in "FIP-518"  and is not in "FIP-206".  There are others but those 2 I know you can flip between to see what I mean.

Thanks in advance!

SW2017 SP5.0 Hotfix #1095621