I have set up individual component properties within each, individual 2D electrical component. Is there a way to populate these component properties to a report (similar to the drawing list)?
Yes. The software by default should come with a number of reports to give you data. We customize ours completely using the SQL editor built into the software, but it's not easy to use. If you can get away with using their reports, and just configuring them without using "expert mode", that would be easiest.
Here's a screenshot of the final result we've got our component list set up to do.
Here is the best discussion that I know of that talks about this topic. There may be others as well though. https://forum.solidworks.com/thread/219471
Our VAR is willing to write custom SQL reports; that may be a more viable option for you to do, and then you can learn enough about them to make minor tweaks. It takes a while to figure out how to do it.
Thank you! I knew it was possible with a little elbow grease.
Thanks again. I'm using the VAR route for other things, however I figured this was something I could do. Maybe not, however I might be taking you up on your offer for support in the next few days.
Retrieving data ...