AnsweredAssumed Answered

how to model tip of half round drill?

Question asked by Joshua Monroe on Jul 2, 2019
Latest reply on Jul 24, 2019 by Jason Young

Been trying to figure this out for a while now, and I'm not getting anywhere. I need to model a lopsided cone with a point that goes through the center line of the drill. I have the curves and profiles modeled, but I can't find a way to revolve a cut around the tip while rotating the profile and translating it down at the same time. I've attached the part model as I currently have it and the dimensions I have. Any help would be greatly appreciated.

Outcomes