Hello SolidWorkers, I want to know how can I change units from IPS to MMGS without affecting model dimension. Thanking you in advance for help.
Override all your dimension units to inches.
Apoligies, that's a bad idea to change every dimension. Any other method, other than scaling?
Scaling is a worst idea (if you are talking about scaling the model).
Muhammad Usman wrote: Apoligies, that's a bad idea to change every dimension. Any other method, other than scaling?
Muhammad Usman wrote:
It sounds like you actually want to change units and dimensions
Hi, if you want ti change the units, but not the dimensions, just change the unit system in the bottom right of the screen :
If you modeled this with IPS settings by mistake, and entered the values you wanted for MMGS, then there isn't a way to switch units and keep the same values. The best solution will likely be to switch units, use the Roll-back bar to suppress all features except the first one, edit the dimensions in that one, then go down the tree, editing the values for each until you're finished.
Retrieving data ...