AnsweredAssumed Answered

Is there a way to make nets flat instead of rounded on the ends?

Question asked by Electrical Engineer on Jun 19, 2019

Hi,

I was wondering if it's possible to make the ends of nets flat instead of rounded. I have hundreds of LEDs that I need to route with 100mil nets and when I connect it to the LEDs the rounded end overlaps other parts on the components. Normally this wouldn't be an issue and I'd just adjust it manually, but I would have to do this almost 300 times for my new project. If not, is there an easier way to route all of my LEDs without having to adjust every single connect?

Outcomes