AnsweredAssumed Answered

rib with a circular and a flat end

Question asked by Cuneyt Dastan on Jun 15, 2019
Latest reply on Jun 17, 2019 by Michael Paul

Like • Show 0 Likes0
Comment • 3

Hey,

I need to add a rib to my part. One end of the rib should be on the circle boss (circular) and the other end has to be linear. Tried a few ways but failed. Could someone help me with that, please?

Michael Paul Jun 17, 2019 11:52 AM

Correct Answer

I swept a surface from the curved to the flat. then extruded from the flange up to the surface.

See the reply in context

Attachments

Part1.SLDPRT.zip181.9 KB
part1.jpg66.7 KB

No one else had this question

Outcomes

3 Replies

Michael Paul Jun 17, 2019 11:52 AM
Unmark Correct
Correct Answer
I swept a surface from the curved to the flat. then extruded from the flange up to the surface.
Attachments
- Part1 with rib.zip199.0 KB
Like • Show 3 Likes3
Actions
- Cuneyt Dastan @ Michael Paul on Jun 17, 2019 6:00 PM
  Mark Correct
  Correct Answer
  Thank you, Michael. I found a way too. Drew 3 sketches and used Loft command.
  Attachments
  - Part2.SLDPRT.zip218.0 KB
  Like • Show 0 Likes0
  Actions
  - Michael Paul @ Cuneyt Dastan on Jun 17, 2019 7:32 PM
    Mark Correct
    Correct Answer
    more than one way to get the same result. glad you figured it out.
    Like • Show 1 Like1
    Actions

rib with a circular and a flat end

Attachments

Outcomes

Attachments

Attachments

Related Content

Recommended Content