AnsweredAssumed Answered

lightweight mode propagate to other parts 

Question asked by Marco Gigante on Jun 13, 2019

Hello I've faced two problems that maybe are connected, and that turn around one point: Lightweight settings changes after saving;

 

- in an assembly, after setting a subassembly in lightweight I save and reopenthe file; after reopening it, most of the parts the assembly is composed with become lightweight , even single parts that are not in subassembly. The subassembly that originally I setted to lightweight had no parts in common with the others. To fix the problem I must set all the parts to resolved and save. If I leave only one part in lightweight the phenomeno comes back again 

 

- in another assembly, after setting a subassembly in lightweight I save and reopen the file; after reopening it I find that the subassembly I setted to lightweight is back to resolved!  

 

Did anyone else experience this before?

Thank you

Outcomes