AnsweredAssumed Answered

Connecting a Wavy Surface

Question asked by Jake Uyeda on Jun 3, 2019

I'm trying to make this wavy surface to pattern instead of the old pattern which wasn't wavy.  

 

 

How would I go about connecting these?  With a surface sweep I assume?  Is there a way to select the edge of this surface all at once?  I seem to be only able select one curve at a time.  

 

 

 

 

Below is a picture of the real part.  You can see the wavyness there.  

 If you have any other suggestions on how to make this wavyness I'm open to ideas.

 

 

Thanks,

Jake

Outcomes