AnsweredAssumed Answered

Extra Surface Left After Cut

Question asked by Jacob Harris on May 30, 2019
Latest reply on May 30, 2019 by Paul Salvador



I am working on a part where I need to cut a section away to create a notched area. However, when I make the cut, there is a surface left that shouldn't exist. 


Ideally, the blue surface would only exist from the black line upwards, while the area beneath the black line would be apart of the faces to the left and right.


I made my sketch plane on the surface marked with the red star. This starred face is perpendicular to all others.


Any tips or clues?





I went and made split lines on the faces mentioned below but made them prior to my notch cuts.


This was the result.



Seems to have fixed the issue.