I am copying and pasting a sheet then using replace model.
As soon as I replace the model, or rebuild the sheet the title block jumps off the page.
Any setting changes or advice on avoiding this would be appreciated.
Was the title block inserted or created while in "Edit sheet format" mode?
Yes It was
Yes it was what? Glenn ask two questions?
Did you insert it according to the help link below. Locking the anchor point into a specific location?
Yes the Title block was created using edit sheet format, anchored to a specific point.
I saved the sheet format and saved the overall drawing template.
Actually I did mean it as a single question, but I can see how that could have been misinterpreted. In any case, I rarely use the "Replace Model", but when I have used it I certainly didn't have that issue, and I don't remember anyone else reporting it here, but that doesn't mean it hasn't happened.
Is it just this one time, or is it a recurring issue? If it's just happened for the first time, have you tried re-booting your computer? I know that's a generic suggestion, but it often cures odd behavior.
I will see what works, thanks for your help.
Rereading your OP, I have to ask another question. You said you saved the sheet format and the overall drawing template.
Did you do this opening up just your template and making these changes, or did you do the template changes from the replaced model with the pasted sheet drawing and saved that as a template? If you did the later, I am thinking you should have done the first. Then when you started a new drawing all would have been well and in place the way you wanted it.
Retrieving data ...