AnsweredAssumed Answered

Bend sheet metal to wrap around and fit cylinder

Question asked by Brandon Lovatt on May 29, 2019
Latest reply on May 29, 2019 by Paul Salvador

Hi all,

 

I've been at this on and off for a while now and I can't come up with a solution. Any ideas how I can recreate this wing to wrap around the cylinder? I've tried a variety of sketch bends and I've tried the Flex command, but can't get it right...

The sheet metal is bent at ~130 degrees where it's attached to a plate, then meets the cylinder at a 45 degree angle where it's the wrapped around and welded to the cylinder

Outcomes