AnsweredAssumed Answered

Anyone else have a problem with Rx after installing SWX2019 SP3.0?

Question asked by Dennis Dohogne on May 7, 2019
Latest reply on Jul 18, 2019 by Dennis Dohogne

I installed SP3.0 yesterday with no apparent problems. As usual a reboot was required and Windows did an update. I suspect it is the update that caused this problem but do not know for sure. I cannot run the Rx, only getting this error screen:

After clicking the OK button then the Rx screen is there for a couple of seconds then closes so I cannot run the Rx.

 

I did run a repair of the SP3.0 installation, but the results are the same. I also sent this to my VAR late yesterday, but have not heard back yet.

 

Does anyone have any suggestions?

Outcomes