AnsweredAssumed Answered

Broken out section failing.

Question asked by Richard Haver on May 3, 2019
Latest reply on May 3, 2019 by John Stoltzfus

Have a drawing of an assembly with a broken-out section in one view. The drawing was fine using SW2018. Have recently updated to SW2019 SP2 and now the Broken-out section is not working as before. The section is good up to a depth of 4.58". at 4.59" I get the message " The model could not be properly sectioned by the section line. Please check that the section line cuts through the model/ components".

Outcomes