AnsweredAssumed Answered

Flex feature how to.

Question asked by Jeroen Harshagen on May 3, 2019
Latest reply on May 7, 2019 by Heiko Sohnholz

Hi everybody.


I have a question about the flex feature.

Attached a assembly that i have a problem with.

I have in the assembly a "test plate left" that  is just a bended plate with a inner radius of 2996 mm

On the inside of the plate i placed a part "upper long" that has to follow exactly that radius of 2996 mm

I need to do this with the feature flex. I know there are more ways to do this but that is not what i want.

I need to do this with the feature flex.

The trim plane 1 i placed exactly in the middle of the part and i used the radius of 2983.75 mm

The length is important. It has to be 57 degree in the radius. If i calculated correctly that will be a length from starting

point of 2967.8 mm.

Somehow i don't get it to follow the radius of the "test plate left".

What am i doing wrong?

Any help is appreciated.