AnsweredAssumed Answered

How would I go about removing/adjusting the corners where the bends are?

Question asked by Joel Franske on Apr 22, 2019
Latest reply on Apr 23, 2019 by Joel Franske

I'm trying to figure out how to adjust/remove the top edge flanges to remove the little bends in the corner but I can't figure out how...

I also tried doing a relief but it doesn't apply to it?

Note: I've tried searching everywhere for this topic but no luck :/ Also I'm fairly new to using Solidworks so if theres a different approach I'm missing, please let me know! Thanks a bunch!



Edit: Uploaded Proper File...