Hi everyone
I am conducting a FlowSimulation analysis using what if scenario. I want to parametrize some geometrical dimensions. When I set up my case and launch the what if, in the input tab when I select the required inputs (geometrical dimensions), by pressing run I face with following error (picture is attached)
"Cannot find parameters in the project:
-1@sketch2@bottomduct-final.part
-1@sketch2@bottomduct-final.part
Do you want to reset the scenario to keep only valid paramteres and start the study?"
Does any one have any idea what the problem is and possibly a workaround for it.
Any comments is highly appreciated
Regards
Kiyarash
