AnsweredAssumed Answered

Hole callout tolerances in derived parts

Question asked by Andrew Buc on Apr 16, 2019
Latest reply on Apr 19, 2019 by Andrew Buc

We occasionally create mirrored derived parts. I'm finding that if I put dimension tolerances in the model of the original part, the tolerances will propagate to the dwg of the derived part--except for hole dimensions. Note the .250 dia x .750 deep hole in the attached screen shots. This is inconvenient, as we virtually always put tolerances on dimensions, and some of our parts have many holes.

 

Is this as good as it gets? I hope not. Thanks.

Outcomes