Hi everyone. I have to do an extrusion at an angled face but struggling to do so. can someone help me out? Direction of the extrusion should be parallel to the surface. Thank you
By default, an Extruded Boss/Base or Extruded Cut will be perpendicular to the sketch plane, but you can change the direction by highlighting the box shown below and then selecting a sketch line or edge to define the direction.
You need to establish a base to apply a 2D sketch, as all 2D sketches need either a face, surface or plane.
If you would upload the part we could give you better tips...
If it is round, create a plane and do a revolve
Retrieving data ...