Skip navigation

Log in to create and rate content, and to follow, bookmark, and share content with other members.

AnsweredAssumed Answered

Routing: How do you remove or delete a fixed length control on a route segment?

Question asked by Hal Seltzer on Mar 19, 2019
Latest reply on Mar 19, 2019 by Hal Seltzer

Like • Show 0 Likes0
Comment • 5

Hello,

I have added a Fixed Length to an electrical cable segment, but now I need to remove it.

I cannot figure our or see how to do this. I prefer not to delete the segment or sketch entities...

Thanks!

No one else has this question

Outcomes

5 Replies

John Stoltzfus Mar 19, 2019 4:28 PM
Mark Correct
Correct Answer
Hal Seltzer wrote:

Hello,

I have added a Fixed Length to an electrical cable segment, but now I need to remove it.
I cannot figure our or see how to do this. I prefer not to delete the segment or sketch entities...

Thanks!
Go here

Find the "Fixed" relation and delete it...
Like • Show 1 Like1
Actions
- Hal Seltzer @ John Stoltzfus on Mar 19, 2019 4:45 PM
  Mark Correct
  Correct Answer
  Your suggestion doesn't work, for the Route Segment, as there were no relevant relations.
  
  Thanks anyways.
  Like • Show 1 Like1
  Actions
  - John Stoltzfus @ Hal Seltzer on Mar 19, 2019 4:52 PM
    Mark Correct
    Correct Answer
    Hal Seltzer - ok then check with Peter De Vlieger
    Like • Show 0 Likes0
    Actions
  - Solid Air @ Hal Seltzer on Mar 19, 2019 4:53 PM
    Mark Correct
    Correct Answer
    How about posting a screen shot to see what you are describing
    Like • Show 1 Like1
    Actions
Hal Seltzer Mar 19, 2019 5:21 PM
Mark Correct
Correct Answer
The Route Segment's sketch is highlighted in blue, it has a unique ID and is currently set to a Fixed Length of 18in.
Right clicking on the Seg. ID in the Property Manager pops up "Delete" or "Clear", BUT neither choice works. Both produce error/warming messages after I hit the green/ok button. Deleting the 18in value does the same....
Like • Show 1 Like1
Actions

Recommended Content