Please I need help support regarding an assembly of the conic custom sheet metals. Scenario is to create cuts relate these two bodies parts to obtain a common volume inside and on exterior side too. Because to create these cuts shapes on flat pattern of each individual sheet metal is very difficult extreme time consuming, I thinking to create these cuts on bend state using geometry reference from assembly level and than to create a config to each sheet metal with cut on bend state for fabrication purpose. Unfortunately, I don’t have idea in this moment how to do it but in stabile way and accurate, I will appreciate very much any ideas solutions, and soon. Is somehow urgent, THANK YOU so much in advance I really appreciate. Please see the assembly and ppt file in attach, thanks.