AnsweredAssumed Answered

How to unfold sheetmetal with "on edge" bends

Question asked by Visy Rangubhatla on Mar 7, 2019
Latest reply on Mar 11, 2019 by Visy Rangubhatla

I have a sheetmetal part with folds "on edge" instead of folds on usual face . I have been modelling these features as tabs. It is a very tedious task to calculate the unfolded length. Is there any way to get the Unfolded length without manual calculation?. I believe you cannot use sketch bend option to create the fold as shown in the image. I'm using SW2016.

Outcomes