Hi to everyone
I have a problem with the mirror feature
I have a mirror on hole wizard ,so far so good
now i made suppress the hole wizard but the mirror still appears (please see the scr24) why?
Is there any wrong? Please tell me how can i fix it
Thank you for your time
Regards
Kostas
Hi Walter
Thank you for your response but i can't send the whole part(assembly) because is too complicated ,but instead i send you a sketch what i want to achieve .Actually i want to create a hole pattern but the 1st pattern isn't the same with the others Please look the scr(25) and you see it
Regards
Kostas
PS The hole pattern instances are parametric
The screen capture doesn't give us enough information to be able to help you. You'll need to post the part. We probably don't need the assembly.
Hi Walter
I can't send you the part because the HW is in assembly mode created so i have to send you the whole assembly .
But i can find the solution for this. I will use macros programming and the problem will solved
Any way thank you for your answer
Regards
Kostas
The images you sent are not close enough to see clearly but it looks like the images are at the sketch level not the part level.
Did you mirror the Sketch or sketch points at another earlier time or have a second sketch that had the hold positions and then later do the Hole Wizard parts?
It seems like you suppressed the Hole Wizard (as shown in the Feature Tree) but your sketch is what seems to be showing in the image. Suppressing the Hole Wizard feature will suppress the Feature in the Part - and this I don't see.
Can you try to make another part that is just a blank body and then put in a Hole Wizard feature in the same way you did in this part and then mirror it and suppress it in exactly the same way and, if it has the same results, post that part.
That or can you copy the part, renaming it and strip out all the other items, do the mirror and if you get the same results you can post that.
Hi Rick
Thank you for your answer, but the problem is in the equation table, because when i made suppress the pattern, when the instances are (0) ,at the equation table i have warning mark (the assembly works) ,but instead the mirror feature is suppressed the HW showed . Any way i think i will solve the problem with macros programming
Regards
Kostas
it's impossible. Please post your part as Walter suggested - Thx
Hello,
I have same question.
When I Suppressed feature in design table it is not suppressing its mirror .
I thought it was my mistake and later on I add mirror feature in Design table.
Regards
Haresh
Why not post your part so we can take a look at it?