AnsweredAssumed Answered

Curved Extruded Cut forming segmented/angled line incorrectly

Question asked by M. W. on Mar 4, 2019
Latest reply on Mar 5, 2019 by Jeremiah Feist


I'm attempting to perform an extruded cut based on a curve. The curve is two straight lines connected by two equal curves, pictured below:


This results in a cut looking like this:

This somehow leaves me with these line segments on the leftmost edge, which in the original curve is a straight line placed on the surface itself.


Any ideas as to how to correct this so the cut edge is perfectly vertical? I've tried changing cut directions and they all result in the same thing.

Is this an issue with Solidworks limiting the amount of polygons in features?


I've attached the part below.


Thank you!