AnsweredAssumed Answered

Lofted Surface has straight line due to spline points

Question asked by M. W. on Mar 3, 2019
Latest reply on Mar 3, 2019 by Paul Salvador


I'm having difficulty with the lofted surface tool-

The two curves i want to loft are made of splines, however they are made of several splines that share a common point.

I can't figure out a way to have the entire multi-piece spline combine into one continuous spline strictly for the purposes of the loft surface.


Is there any way for me to force Solidworks to ignore coincident points of separate splines in the same sketch and assume the spline as one whole piece?


I've attached a few pictures below as well as my part file.

Many Thanks!!